The weather remained crisp, clear, and dry to complete the installation of the metal roof.
The metal roofing is standing seam at twenty four feet four inches in length.
Howard brought the metal panels up one by one from the "bone yard".
Each panel was swept clean and wiped where needed.
To maneuver the panels on top of the roof, the panels gets choked up the driveway then backed up and turned at the same time to stage the panel 90 degrees from its origination and bring it parallel with the roof edge.
The panel gets leveraged against the step to the pump house and raised to the edge of the roof side.
The panel then gets set on the edge of the ladder to stabilize the center and raise the edge enough for me to grab and pull onto the roof.
Howard was able to take a break between panels enough to eat his lunch and rest a bit. For seventy six years of being in human form on this earth, he is outstanding in experiencing life to the fullest.
The panels were very simple to lay and install. Highly recommend these over corrugated or shingles.
The metal panels were very quick to install. The overhang was perfect on both ends.
Halfway through the roof and still so much daylight left.
Tools for the trade for metal roof installation. By afternoon, the roof was on, and the house was technically in the dry.
